Spectre Ballistics 10/22 Adaptor
This was an article originally published in November/December issue of the Canadian Firearms Journal, distributed through The NFA. It can be downloaded and read here.
I had the opportunity to test the 10/22 Magazine Adapter from Spectre Ballistics, a local Alberta company that’s big on creative solutions. This handy device allows you to use Remington 597 magazines in a Ruger 10/22. Why does anyone want that? Simple, magazine capacity. Rugers, due to the existence of a rare pistol variant called the “10/22 Charger” can only have a 10 round magazine because the standard 10/22 magazine is now considered a pistol magazine. The Remington 597, on the other hand, only comes in rifle models and as such is not subject to magazine capacity laws. Under Canadian law, you can modify a firearm to take any magazine and the magazine is only subject to the laws of its original manufacture. This is why so many people with AR-15s, normally only allowed 5 rounds, would buy 10 round LAR (AR-15 pistol) magazines and use them in their rifles and be legal. However, it is important to note that it is illegal to modify a magazine to fit a rifle.
So, here’s the scoop. Install is a snap, take out your old magazine, put this in its place and you are done. No milling, drilling, or gunsmithing. This I liked. As for reliability, the only issues I could make happen were pushing the magazine forward while firing, it would prevent the action from going into battery completely, creating a light strike. I twisted, pushed, and pulled every which way with no other issues, even firing the rifle upside down (in a safe fashion) caused no troubles.
After some usage, the only flaw I can find is that Remington 597 magazines are not great. I had 2 of them shatter springs. Initially I thought the adapter was causing feed issues, but upon inspection, my magazines sounded like maracas. I took them apart and found that what should have been 1 long spring was 9 pieces in one magazine and 4 pieces in the other. A bit of research online shows that some people have had much better results with the 597 magazines if they do a break in process. The process is simple, only load it to 5 rounds a few times, then only 10 a few times, then 15 so on and so on.
One thing I was hesitant about, but really came around on, is the magazine release being on the left-hand side. I worried it would be awkward, it was not. It turns out I much prefer it over the original Ruger release. With the factory 10/22 magazine, and release, I found to remove the magazine I would maintain control of the rifle with my right hand and then use my left thumb to hit the release and catch the magazine in my palm as it fell. With this adaptor and longer magazine, I can maintain control of the rifle with my right hand, grab the magazine with my left, then use my left thumb to hit the release and pull the magazine out. This allows me to always have positive control of both the firearm and the magazine. In a rushed reload, like say, a shooting competition, you could have a fresh magazine in your left hand, hit the release with your left index finger, allow the magazine to free fall (it has enough weight and clearance to do so) and then insert the fresh magazine.
I think anyone who picks up one of these adaptors will be happy they did. After being lent one to test, I’ve decided to buy one. You can buy them direct from www.SpectreBallistics.com
Posted in Marksmanship, Published Workwith no comments yet.
Leave a Reply